RSR

Telecommunications Trainer

Hands-on Telephony, LAN, CATV,
Fiber Optic Experience

TELECOMMUNICATIONS skills are necessary to succeed today. "TCM-200" introduces you to telephony, cabling, LAN, CATV and fiber optics with one self-contained unit. A comprehensive workbook walks you through the world of telecommunications from the very basic fundamentals of electronics to networks. Priced under $225.00, the TCM-200's innovative design covers more material in less time than units costing thousands of dollars more. The TCM-200 delivers the platform to teach the skills your students need FOR TODAY AND TOMORROW.

* Tools, workbook, supplies and meter
available at additional cost

• Punch-Down Tool - Impact type w/blades for 66 and 110 punch down blocks
• Crimping Tool - Deluxe ratchet type with four different dies
• Wire Strippers - (3) for coax cable, data / phone cable and hook-up wire
• Long nose plier
• Diagonal cutter
• Screwdrivers (2)
• Magnifier - lighted
• Telephone Set
• Tool Box

• 66 Punch Down Block
  25x4 Split Punch Down Block for hands-on training with telephone cabling.
• Type 110 Punch Down Block
  For hands-on training with telephone cabling. These are configured for use in conjunction with and separately from the 66 Block
• Dial Tone
  "TONE ON-OFF" switch to supply tone selected by "TONE SELECT" switch to RJ11 type J1, J2, J3 and 110 block type PB5, PB6 and PB7.
• Ring Signal
  Push-button switch to supply 80VAC, 20Hz ring signal to J5, PB5, PB6 and PB7.
• RJ-11 Connectors
  Use 2 or more telephones for full-duplex communication to simulate a local loop and CO. Use connected Type 110 connectors to test ring, dial, ringback and busy tone signals. Note that J2 and J3 are connected to pin 3 of PB5, PB6 and PB7. J1 is connected to pin 1 of PB5, PB6 and PB7. J4 is connected to pin 5 of PB5, PB6 and PB7. J5 is connected to pin 7 of PB5, PB6 and PB7.
• RJ-45 Connectors
  Use for testing various LAN cables.
• Cable Test
  Use with interchangeable PC Boards to test data cables with various pin-out standards. The test results are indicated by 4 LED's.
• Prototyping Area
  480 tie-point breadboard.
• 5V and 12V DC Power Supply
  For prototype circuits built on breadboard.
• BNC Connector and F Connector
  50 Ohm / 75 Ohm Terminated for cable assembly instruction and prototyping use with RG58 and RG59 and RG6 cable
.
• 1KHZ Tone
  Fixed frequency 1KHz TTL clock signal.
• Out, In, Phone and OPT
  The telephone audio and signal is provided to IN PHONE connector, modulated using PDM technique, converted into light and sent over the fiber-optic cable
• Connectors
  attached to OPT connectors then converted into electrical signals demodulated and routed to OUT PHONE connector.

01TCM200        T-Comm Trainer (TCM-200)       $220.95

3300TCOM200     Lab Manual / Work Book           34.95

3200TCOMCSK200  Component and Supplies Kit       39.95

3200TCOMTK      Tool Kit                        119.95

Our Indexes