For International Shipping please call us: 1-800-972-2225 or email

PmodGPS: GPS Receiver

PmodGPS: GPS Receiver

Pmod SF3: 32 MB Serial NOR Flash

Pmod SF3: 32 MB Serial NOR Flash

PmodDHB1: Dual H-bridge

The Pmod DHB1 uses the Texas Instruments® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals.


Dual H-Bridge capable of 1.5A RMS

Two quadrature encoder channels for motor feedback

Two JST 6-pin ports for connection to Digilent motor/gearbox

Over-current protection

Recommended 10.8 V max motor voltage

Logic input voltage range of 2.5 V to 5 V

Small PCB size for flexible designs 1.3� � 1.8� (3.3 cm � 4.6 cm)

Follows Digilent Pmod Interface Specification Type 5

Write Your Own Review
You're reviewing:PmodDHB1: Dual H-bridge
Your Rating
PmodDHB1: Dual H-bridge

  WARNING: This product can expose you to chemicals including DEHP which is known to the State of California to cause cancer and to cause birth defects or other reproductive harm. For more information go to: