For International Shipping please call us: 1-800-972-2225 or email

PmodDHB1: Dual H-bridge

PmodDHB1: Dual H-bridge

PmodSTEP: Stepper Motor Driver

The Pmod STEP provides a four channel drive for a stepper motor via the ST L293DD. Users may wire two pairs of channels in series to drive up to 600 mA of current per channel and can view the current status of a GPIO signal through a set of user LEDs.


Stepper motor driver for 4 and 6-pin motors

Can drive both motors simultaneously

Multiple LEDs to indicate signal propagation

Jumper for optional external power

Small PCB size for flexible designs 2.8� � 1.3� (7.1 cm � 3.3 cm)

2�6-pin Pmod connector with GPIO interface

Follows Digilent Pmod Interface Specification Type 1

Write Your Own Review
You're reviewing:PmodSTEP: Stepper Motor Driver
Your Rating
PmodSTEP: Stepper Motor Driver

  WARNING: This product can expose you to chemicals including DEHP which is known to the State of California to cause cancer and to cause birth defects or other reproductive harm. For more information go to: